Khamail Abdul\u2011Mahdi Mosheer1
Received: 10 September 2023 \/ Revised: 9 April 2024 \/ Accepted: 9 April 2024
<\/p>\n\n\n\n
\u00a9 The Author(s), under exclusive licence to Springer Nature Switzerland AG 2024
Abstract
This study is intended to experimentally investigate of the structural behaviour of simply supported reinforced concrete
beams loss in main steel reinforcement which compensated by precast concrete. six simply supported reinforced concrete
beams with various ratios of main steel reinforcement (\u03c1) equal to 0.00969, 0.00646, and 0.00323. Each two beam have same
ratio of reinforcement, one of them supported by precast concrete layer. The layers made by high mechanical propertiesn
So, Slurry-infiltrated fibre concrete with 17.7 MPa tensile concrete and 87 MPa compressive strength was used to cast 3 mm
thickness layers with 7.5% volume frication. The hard reinforced concrete beam and precast concrete layer were bonded
together on beam’s tension face to product composite segment. The result show that decrease in ratio of main reinforcement
lead to reduction in ultimate load by about 28% and 58% for 0.00646, and 0.00323 as compare with reference beam with
\u03c1 = 0.00969. The ultimate flexural capacity of beams with bonded precast concrete segment was found to be best related to
the beams without it, where they reach to 98% and 69% of reference beam flexural capacity. On the other hand, the ultimate
load increased as compared with same beam without precast layers by about 31.16%, 36.0%, and 62.71% for main steel
reinforcement ratios (\u03c1) equal to 0.00969, 0.00646, and 0.00323 respectively. Furthermore, the strength by precast layers
could improve the cracking behaviour, and stiffness of the beams.
Keywords Beams \u00b7 Loss in steel reinforcement \u00b7 High tensile and compressive strength \u00b7 Precast concrete<\/p>\n\n\n\n